A broken High Pressure Cleaner would obviously be a headache. It is possible that the damage is in the engine, or it may be in the nozzle. In fact, having a High Pressure Cleaner can be a good investment. You can use it to wash vehicle steam, clean paving blocks from moss and clean dusty carpets.
Cleaning with High Pressure Cleaner also saves time because of its strong power. The spray can be set to single spray mode that focuses on a single point or spray spreads. Because of this versatile function, it is not uncommon for the High Pressure Cleaner to experience interference until it becomes damaged. It is a shame if the High Pressure Cleaner is damaged and cannot be repaired because its use is not optimal.
Damage to this High Pressure Cleaner can be in the form of too low water or a worn out engine. Don't panic, here are the solutions to fix a damaged High Pressure Cleaner that can be done!
1. Too low water flow
Hearing High Pressure Cleaner, the thing that is imagined is definitely a very large spray power because it can immediately clean dirty surfaces. However, if the High Pressure Cleaner is damaged, the water flow will actually weaken so that it doesn't come out at all. Basically, a pump works by compressing a certain volume of water, so that the pressure becomes high.
If the incoming water flow rate is low, the amount of water that enters the pump does not reach the maximum volume and the pressure that comes out is not high. The solution, connect the machine to higher water and check the water pressure that comes out. If it doesn't fit, reconnect it to another water machine.
2. Leak in hose
The hose used for High Pressure Cleaner is different from the hoses in general. Due to the higher pressure, the hose is specially made to withstand the high pressure from within. However, sometimes the hose cannot withstand external pressure.
If only the hose is run over, stored folded, or the connection is not suitable, water might leak and the pressure will decrease. Therefore, first check the hose for leaks and also check the o-ring. If the o-ring is damaged, then immediately replace it with a new one. Do not patch the leaking hose, you should just replace it to prevent further leaks.
3. Seals on worn pumps
This seal serves to withstand pressure in the system. The way it works against the wall of the machine makes it easy to erode little by little. Not surprisingly, this seal is often worn out and as a result it cannot hold the pressure well, so the pressure is leaking. You should check the pump part of the engine. If the seal is worn, replace it with a new one immediately. Re-install the pump on the engine and check if there are still leaks or not.
Also read: Making Your Own High Pressure Sprayer
4. The High Pressure Cleaner hummed off
The most common problem with a damaged High Pressure Cleaner engine is that the engine does not start but makes a hum. The reason could be because the capacitor engine has weakened, so it is not strong enough to lift the dynamo when it is turned on. The solution, you have to replace the capacitor with a new one. Also pay attention, when replacing the capacitor make sure it is the same size as the capacitor to be replaced.
5. The High Pressure Cleaner machine is totally dead
When turned on, your High Pressure Cleaner machine suddenly shuts down? Before you panic, first find out the cause! Usually the engine dies because the cable line is cut off. The solution, you can check the entire series of cables contained in the High Pressure Cleaner machine. If there is a broken cable, for example the cable on the power or switch, you can replace this dead part with a new one. If the cord is exposed, connect the cable and wrap it with adhesive.
That's the solution to fixing a broken High Pressure Cleaner at home. If the damage is severe, it is best to consult an experienced technician so that the damage does not spread. If the High Pressure Cleaner can't be saved, the only way is to buy a new High Pressure Cleaner. Hopefully the information above about how to fix a damaged High Pressure Cleaner can help you!
Also read: How to use the High Pressure cleaner